Specifications

32
Controller Basic Programming Mode
Programming the 'Temperature'.
1. The stored set ‘Temperature’ is displayed (default
350°F - 176.5°C) with a flashing ‘F’ or ‘C’ for
Fahrenheit or Celsius.
2. To change the temperature, press either;
i. 'Timer 1 - Up ’ to increase the time.
Or
ii. 'Timer 3 - Down' to decrease the time.
3. When changing the temperature, the value changes
at a slow rate for the first 8 degrees and then at an
increasing rate.
4. Press the Programme Key ‘P’ once the desired
temperature is reached, the temperature change will
be accepted and the display will step on to the next
parameter.
Programming the Keypad 'Lock - Unlock’.
Refer to 'Programming the Password Protection' at the start
of this section.
To Exit the Programming Mode.
To exit the Programming Mode at any stage of the
programming, press and holding the Programme Key ’P’ for
approximately 3 seconds, or do not press any key for 2
minutes. The display will revert to the ‘Idle Mode’.
Hold for 3
Seconds.
Factory Default Settings
350°F - 176.5°C