Specifications

35
Controller Advanced Programming Mode
Setting the ‘Temperature Units’.
14. The user may select from ‘F’ (Fahrenheit) or
‘C’ (Celsius).
15. To change the 'Temperature Units', press either
'Timer 1 - Up’ key or 'Timer 3 - Down' key to change
the selection.
16. Press the Programme Key ‘P’, the change will be
accepted and the display will revert to the ‘Idle Mode’.
NOTE: Pressing and holding the Programming Key for approximately 3 seconds during the
Advanced Programming Mode (Or not pressing any keys for 2 minutes) the appliance will
exit the Advanced Programming Mode and return to the ‘Idle Mode’.
System Programmable Default Settings
This section shows the system parameters for this model and contains a table of the ‘Programmable
Default Settings’, (These settings can be edited from the Control Panel when in either ‘Controller Basic
Programme Mode’ or 'Controller Advanced Programming Mode').
Programmable Default Settings
Basic Programming Mode
Timer 1 ‘L’ Cook Time 3:00 min.
Timer 2 'Ctr’ Cook Time 3:00 min.
Timer 3 'R’ Cook Time 3:00 min.
Temperature Set Point 177°C (350°F).
Melt Cycle Mode L (Liquid).
Keypad Lock or Unlock Unlock.
Degrees; °F or °C °C.
Advanced Programming Mode
Number of Product Timers 3.
Timing Mode S.t (Straight).
Temperature Offset 0°.
Temperature Display Mode t. -0 = 'HEAt' or 'droP'.