Service manual

1
1
Specifications
© Moffat Ltd, January 2007
Revision 1/
Blue Seal Evolution series G51 Gas Cooktops
Model Numbers Covered in this Specification
G512D-[1]-[2] 2 Open Burners.
G512C -[2] 300 mm Griddle.
G514D-[1]-[2] 4 Open Burners.
G514C-[1]-[2] 2 Open Burners + 300 mm Griddle.
G514B -[2] 600 mm Griddle.
G516D-[1]-[2] 6 Open Burners.
G516C-[1]-[2] 4 Open Burners + 300 mm Griddle.
G516B-[1]-[2] 2 Open Burners + 600 mm Griddle.
G516A -[2] 900 mm Griddle.
G518D-[1]-[2] 8 Open Burners.
G518C-[1]-[2] 6 Open Burners + 300 mm Griddle.
G518B-[1]-[2] 4 Open Burners + 600 mm Griddle.
G518A-[1]-[2] 2 Open Burners + 900 mm Griddle.
[1] - Open Burner Options;
F - With Flame Failure Protection.
PF - With Pilot and Flame Failure Protection.
[2] - Base Stand Options;
B - Bench Mount.
CB - Cabinet Base (excluding G512 series).
LS - Leg Stand (excluding G512 series).
RB - Refrigerated Base (G516 and G518 series only).
Gas Supply Requirements - Non UK Models
* - The burner operating pressure is to be measured at the manifold test point with two
burners operating at full setting. The operating pressure is ex-factory set, through the appliance
regulator and is not to be adjusted, apart from when converting between gases, if required. (Refer to
the ‘Gas Conversion’ section for details).
Natural Gas LP Gas (Propane)
Input Rate (N.H.G.C.)
- each Open Burner
28 MJ/hr
(26,540 Btu/hr)
28 MJ/hr
(26,540 Btu/hr)
- each 300 mm Griddle Section
21 MJ/hr
(19,900 Btu/hr)
21 MJ/hr
(19,900 Btu/hr)
Supply Pressure
1.13 - 3.40 kPa
(4.5” -13.5” w.c.)
2.75 - 3.40 kPa
(11” -13.5”w.c.)
Burner Operating Pressure
0.95 kPa (*)
(3.7” w.c.)
2.6 kPa (*)
(10.0” w.c.)
Gas Connection (G512) ½" BSP male thread
Gas Connection (G514/6/8) ¾" BSP male thread