Specifications

11
Installation
Clearances
NOTE: Only non-combustible materials can be used in close proximity to this appliance.
* Side clearances can be 50mm when the adjacent surface is at least 100mm below the cooking
surface.
Assembly
NOTE:
• All Models are delivered completely assembled. No further assembly is required, with the
exception of all Leg Stand Models (G514-LS, G516-LS G518-LS), these will require
assembly. Refer to the information below for assembly instructions.
• This appliance is fitted with adjustable feet to enable the appliance to be positioned
securely and level. This should be carried out on completion of the gas connection. Refer
to the ‘Gas Connection’ section.
Optional Accessories (Refer to the 'Replacement Parts List' at the rear of this manual)
• Plinth Kit. For installation details, refer to the instructions supplied with each kit.
Bench Models
1. Check that all the feet (and castors) are securely fitted.
2. Adjust the feet to make the Cooktop steady and level.
Fitting the Leg Stand to the Cooktop
1. Remove all pot stands, trivets, open burners and
griddle plates.
2. Lower the cooktop onto its rear face.
3. Attach the four cooktop legs to the leg mount points
on the underside of the cooktop unit.
4. Secure each leg hand tight.
5. Align the 4 round holes in the corners of the base
tray with the 4 cooktop legs already fitted. (Ensure
that the base tray is orientated with the sloping edge
of the base tray facing the front of the appliance).
6. Slot the base tray onto the 4 cooktop legs and push
fully home.
7. Secure the base tray to the cooktop legs by screwing
the two front adjustable feet supplied, into the base
of the front cooktop legs. Secure each adjustable
foot, hand tight.
8. The two rear leg housings can be fitted with either
adjustable legs or rollers. (See Figure 1).
9. Fit the rear rollers to the rear leg ring plates and
secure using the locating bolts supplied, tighten
bolts using a 10mm spanner.
10. Lift the cooktop back onto its legs and refit all the
items removed at Item 1 above.
Combustible Surface Non Combustible Surface
Left / Right hand side 250mm (*) 0mm
Rear 50mm 0mm
Fig 1
Sloping Edge
of Base Tray
Rear Roller
Base Tray
Cooktop
Legs
Leg Mount
Points
Cooktop
WARNING:
TO PREVENT EQUIPMENT DAMAGE AND RISK OF INJURY, REMOVE ALL TRIVETS, BURNER HEADS, GRIDDLE
PLATES AND OTHER REMOVABLE ITEMS PRIOR TO FITTING THE LEG STAND.