Specifications

Gas Conversion and Specifications

Main Burner Injectors

1. Unscrew and remove the main burner injectors

(12.7 mm A/F) located in front of main burner

venturi openings.

2. Determine the correct injectors for the

corresponding gas from the ‘Gas Specifications

Table’ at the end of this section.

3. Screw in the correct sized injectors. Refer to the

‘Gas Specifications Table’ at the end of this

section.

Pilot Burner Injectors

1. Unscrew the pilot supply tube from the pilot

burner fitted to the mounting bracket and

remove the pilot injector.

NOTE: On appliances fitted with piezo igniter

electrodes, to prevent damage to the

electrode, unscrew and remove the

electrode from the mounting bracket before

unscrewing the pilot supply tube.

2. Determine the correct sized pilot injectors for the

corresponding gas from the table overleaf.

3. Fit the correct sized injector into the pilot burner

and re-connect the gas supply tube to the pilot

burner.

4. Refit the piezo igniter electrode to the mounting

bracket and tighten hand tight.

Gas Controller

NOTE: For Twin Tank Fryers only, the units will be fitted with 2 gas controllers. These controllers

operate independently of each other. The gas regulators and pilot adjustment will need to

be carried out separately for each gas controller.

Main Burner Operating Pressure Adjustment

a. Connect a manometer to the lower test point (Burner Pressure) on the gas control valve located

through the access hole in the control panel.

b. Remove the slotted cap located directly below the main gas control knob on the gas control

valve, this will reveal an operating pressure adjusting screw.

c. Light the main burners and adjust the adjusting screw to obtain the correct burner pressure for

the type of gas being used. Refer to the specification table shown at the end of this section.

d. Refit the slotted cap to the screw adjustment point.

Thermocouple

Thermopile

Piezo Igniter

Pilot Burner

Fig 10

Fig 11

Main Burner

Injector