Specifications

30
Gas Conversion and Specifications
Gas Specifications
- Australia / New Zealand:
- UK Only:
NOTE:
(*) The burner operating pressure is to be measured at the upper test point (Supply Pressure)
on the gas control valve located behind the access door and through the access hole in the
control panel, this is to be carried out with all burners operating at the 'High Flame'
setting. Refer to the ‘Gas Conversion and Specification’ Section for further details.
Natural Gas.
(G20)
Propane
(G31)
Main Burner Injectors Ø 3.10 mm Ø 1.90 mm
Pilot Burner Injectors 0.45 0.30
Pilot Screw Adjustment
Full Out (CCW) 1½ turns out (CCW)
Burner Operating Pressure
0.98 kPa (*)
(9.8 mbar)
2.50 kPa (*)
(25 mbar)
Supply Pressure
20 mbar 37 mbar
Natural Gas. LP Gas (Propane)
Main Burner Injectors Ø 3.10 mm Ø 1.90 mm
Pilot Burner Injectors
0.62 0.35
Pilot Screw Adjustment
Full Out (CCW) 1½ turns out (CCW)
Burner Operating Pressure
0.98 kPa (*)
(9.8 mbar)
2.50 kPa (*)
(25 mbar)
Supply Pressure
1.13 - 2.0 kPa 2.75 - 3.0 kPa