User's Manual

User Manual • Technical Specifications & Dimensions • Page 13
SAT 265 Specifications
Enclosure
.75” MDF with 1” front / rear baffle and internal bracing
.25” x 20 inserts for attachment of OmniMount type 60
brackets
Dimensions (H x W x D):
19.8” (503 mm) x 8” (203 mm) W x 11.63” (296 mm) D*
* For complete dimensions see diagram below
Weight: 48.5 lbs. (22 kg)
1” Tweeter
Dual Ring Radiator Diaphragm with integral waveguide
High-power handling ferrite motor structure
Fully video shielded
Dual 6.5” Hemispherical Woofers
High–excursion design with a vented motor
Cast aluminum frame
1.5 inch aluminum voice coil
Copper shorting rings for lower distortion
Ultra low power compression design
Mica filled polypropylene cone with rubber surround
Fully video shielded
Amplifiers & Electronics
3 x 100* Watts into 4-Ohm (for each woofer and tweeter)
.01% THD + noise at rated power @ 1 kHz
* Power is limited by protection circuitry
XLR electronically balanced input
Fixed and Adjustable gain controls
B00® optimized crossover
“full space” & “half space” / baffle compensation controls
Tweeter level trims
Input impedance: 10K balanced
Common Mode Rejection 40dB typical @ 60Hz
Voltage Sensitivity (high gain) 200mv = 90dB SPL @ 1 meter
Maximum Input Level: +24dBu balanced
Frequency Response: +/- 3dB 80Hz to 30kHz
+/-1.5dB 200Hz to 15kHz
8.00
203.2 mm
19.79
502.6 mm
2.75
69.9 mm
5.00
127.0 mm
3.06
77.8 mm
1/4 x 20 inserts
10.25
260.4 mm
11.63
295.4 mm
4.67
118.6 mm
3.31
84.0 mm
11.87
301.5 mm
USER MANUAL • 11 • TECHNICAL SPECIFICATIONS & DIMENSIONS
SAT 265