User manual

User Manual • Technical Specifications & Dimensions • Page 13
SAT 6.5 EXR Specifications
Enclosure
.75” MDF with 1” front / rear baffle and internal bracing
.25” x 20 inserts for attachment of OmniMount type 60
brackets
Dimensions (H x W x D):
14.75” (374 mm) x 10” (254 mm) W x 14.13” (358.9 mm) D*
* For complete dimensions see diagram below
Weight: 35.5 lbs. (16.2 kg)
1” Tweeter
Dual Ring Radiator Diaphragm with integral waveguide
High-power handling ferrite motor structure
Fully video shielded
6.5” Hemispherical Woofer
High–excursion design with a vented motor
Cast aluminum frame
1.5 inch aluminum voice coil
Copper shorting rings for lower distortion
Ultra low power compression design
Mica filled polypropylene cone with rubber surround
Fully video shielded
Amplifiers & Electronics
2 x 100* Watts into 4-Ohm (for each woofer and tweeter)
.01% THD + noise at rated power @ 1 kHz
* Power is limited by protection circuitry
Dual XLR electronically balanced inputs:
Extended Range / 40Hz
Bass-Managed / 80Hz
Fixed and Adjustable gain controls
B00® optimized crossover
“full space” & “half space” / baffle compensation controls
Tweeter level trims
Input impedance: 10K balanced
Common Mode Rejection 40dB typical @ 60Hz
Voltage Sensitivity (high gain) 200mv = 90dB SPL @ 1 meter
Maximum Input Level: +24dBu balanced
Frequency Response (40Hz input): +/- 3dB 40Hz to 20kHz
+/-1.5dB 200Hz to 15kHz
10.00
254.0 mm
14.75
374.6 mm
5.00
127.0 mm
3.06
77.8 mm
2.75
69.8 mm
3.62
92.1 mm
1/4 X 20" INSERTS
12.75
323.9 mm
14.13
358.9 mm
1.47
37.5 mm
1.70
43.3 mm
USER MANUAL • 11 • TECHNICAL SPECIFICATIONS & DIMENSIONS
SAT 6.5 EXR