User's Instructions

CellTrackIT user manual Version 0.8 Page 20
Figure 15. Proper Mounting of CellTrackIT Repeater.
Plug in the power cord and attach the antenna coaxial cable with the male
TNC connector end to the RX/TX TNC hookup. Do not connect the antenna
to the RX connector. Only the RX/TX connector must be used. The other
end of the cable should have a male N Type connector that screws to the
antenna (Appendix 2).
Figure 16. CellTrackIT Repeater Connections.
Both the Node Receiver and repeater antenna connections at the N Type end
should be wrapped in water proof tape to prevent corrosion due to water
seepage (ACE Rubber Splicing Tape --ACE 30986).
• Verifying Repeater Operation. Once the repeater is installed in the
attic and the connections are completed check the two red LEDs for
activity. The POWER LED should be on while the DATA LED will be
flickering in an on-off mode. This flickering shows some Transponder
signals are received.
Trouble shooting
Observe LED lights. The repeater will not transmit if power isn’t applied to it or
if it doesn’t receive any signals from the transponders.