Owner Manual

ManualsBrandsBlue Wave Products ManualsHot Tubs & SaunasPoolside Solar Freestanding Outdoor Shower

INSTRUCTIONS

Before you begin, please check to ensure you have all the parts. Read ALL directions before beginning.

Connection Fitting

Elbow Fitting

Shower Head

Teflon Tape

Setscrew

Handle

Hose Connector

No. Qty.

Description

Installation

In order to get the most satisfaction and pleasure from your shower,

please pay attention to the following details:

1. The solar shower must be installed on the portable base to make

sure it is stable and safe for user.

2. The solar shower includes a base plate. This has 4 prefabricated

holes for attaching the main shower body.

3. Assemble two of the base plates together, do the same with

the other two, and then put these two assemblies together to form

the whole base before attaching main shower body.

4. Install the solar shower in a location with optimal sunshine.

5. Connect the inlet of the solar shower to your home’s water system

using a standard garden hose.

6. Make sure you have a valve installed before the inlet of the solar

shower for turning the water on and off.

7. To prevent being scalded by hot water, ALWAYS make sure the

shower valve is in the cold water position (blue) before turning on

the shower, then turn the valve on and gradually adjust the water toward the hot water position (red), until reaching the

desired temperature.

8. WARNING! When exposed to very strong sun rays, the water temperature coming from the solar shower may reach

temperatures as high as 140˚ F (60˚ C).

Base

NUP1000

Part No.

NUP1001

NUP1002

NUP1003

NUP1004

NUP1005

NUP1006

NUP1007

Step 1 Step 2 Step 3 Step 6

Hose

Connector

Step 5Step 4

NU1625

3. Connection Fitting

Coupler 2

1. Shower Head

2. Elbow Fitting

Main

Shower

Body

Washer 1

Washer 2

Coupler 1

4. Handle

Washer 3

7. Screw

Cover

5. Hose Connector

Ground

8. Base

NOTE: Use Teflon tape on all threaded fittings.

Summary of content (5 pages)

PAGE 1
INSTRUCTIONS NU1625 Before you begin, please check to ensure you have all the parts. Read ALL directions before beginning. No. Description Qty. 3. Connection Fitting Part No. 2. Elbow Fitting 1 Shower Head 1 NUP1000 2 Elbow Fitting 1 NUP1001 3 Connection Fitting 1 NUP1002 4 Handle 1 NUP1003 5 Hose Connector 1 NUP1004 6 Teflon Tape 1 NUP1005 7 Setscrew 4 NUP1006 8 Base 4 NUP1007 Washer 2 Washer 1 Coupler 2 Coupler 1 Main Shower Body 1.
PAGE 2
INSTRUCTIONS (Cont.) Initial Set-up of the Shower 1. Turn shower handle to FULL ON HOT position. 2. Turn on water supply to garden hose to fill shower. Shower will take about 2 minutes to fill. NOTE: Filling tube with valve in hot position ensures no air pockets are trapped in shower. This procedure is used for initial set up ONLY. 3. When water flows from shower head, turn shower handle off. Turning the shower off allows the water to begin heating. 4.
PAGE 3
INSTRUCTIONS NU1625 Avant de commencer, assurez-vous d’avoir toutes les pièces. Lire toutes les instructions avant de commencer. No Description No de pièce Qté. 3. Écrou de blocage 2. Raccord coudé 1 Pomme de douche 1 NUP1000 2 Raccord coudé 1 NUP1001 3 Écrou de blocage 1 NUP1002 Coupleur 1 4 Poignée 1 NUP1003 1.
PAGE 4
INSTRUCTIONS (suite) Configuration initiale de la douche 1. Tournez la poignée dans la position FULL ON HOT 2. Ouvrez l’alimentation de l’eau du tuyau d'arrosage pour remplir la douche, cela ne prend que deux minutes environ. NOTE : en remplissant avec le robinet à la position HOT, vous vous assurez qu’il n’y aucune poche d'air emprisonnée dans la douche. Cette procédure s’applique lors de la configuration initiale SEULEMENT. 3.
PAGE 5
NOTICE!!! PLEASE USE THE PROVIDED QUICK CONNECT HOSE ADAPTOR TO EASILY ATTACHED YOUR STANDARD GARDEN HOSE TO THE NU1625 SOLAR SHOWER STEP 1 STEP 2 STEP 3 STEP 4 STEP 5 STEP 6 – MAKE SURE TO PULL BACK ORANGE SLIDING LOCK MECHANISM AND FIRMLY PRESS BLACK CONNECTOR PIECE INTO QUICK CONNECT PART.