Owners manual

ManualsBrandsBlue Wave ManualsPool AccessoriesAquajet Floating Pool Light Show & Fountain

INSTRUCTIONS FOR AQUA JET FOUNTAIN™

INCLUDES: Fountain, remote control and AC adapter

WARNING

SEIZURES - People with photosensitive epilepsy can have seizures triggered by ickering or

ashing lights such as strobe or disco lights.

Do not operate the product in water while it is plugged in. Serious injury and/or fatal may result.

To prevent damage to the pump, do not run the fountain out of water.

KEEP OUT OF REACH OF CHILDREN. THIS IS NOT INTENDED AS A TOY.

NOTE

• The product projects light show approximately 10-15 feet in diameter.

• Fountain has preset programming running at various heights.

• Light show intensity will vary according to color, size and depth of your pool.

GETTING STARTED

IMPORTANT: Product must be charged before use.

1. Plug the AC adapter into an electrical wall outlet.

2. Remove the charging port plug located on top of the fountain

3. Plug the AC adapter connector into charging port.

4. When the product is fully charged, 6 to 8 hours, the charging indicator

(red light) will turn blue.

5. Unplug the charger from the charging port.

(ENGLISH)

~ continued ~

Charging Indicator

Charging Port/Plug

IR Eye for Remote

IR Eye

Fountain and Light Show

Control Button

Fountain and Light Show

Control Button

Summary of content (4 pages)

PAGE 1
INSTRUCTIONS FOR AQUA JET FOUNTAIN™ (ENGLISH) INCLUDES: Fountain, remote control and AC adapter WARNING SEIZURES - People with photosensitive epilepsy can have seizures triggered by flickering or flashing lights such as strobe or disco lights. Do not operate the product in water while it is plugged in. Serious injury and/or fatal may result. To prevent damage to the pump, do not run the fountain out of water. KEEP OUT OF REACH OF CHILDREN. THIS IS NOT INTENDED AS A TOY.
PAGE 2
6. Replace the charging port plug, pressing it firmly in place so water does not seep into the port. 7. Remote control comes with a button cell battery (lithium CR2032, 3 volts) installed. Pull clear plastic tab at side of remote to enable battery connection. OPERATION You can use the remote control or the button on the product to operate the fountain and light shows. The remote control must be pointed directly at the product for it to function.
PAGE 3
TROUBLESHOOTING Problem Possibilities/Solutions Fountain will not function Check to make sure it is charged Try pushing another button, or using the remote Make sure the fountain body is not cracked, causing a leak Make sure the fountain was not run or placed in the pool with the Charge Port Cap loose or off, causing a leak Light show will not function Check to make sure it is charged The fountain spray height seems low, or uneven Check for blockages on the intake screen at the bottom of the fountai
PAGE 4
CAUTION: Changes or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.