Installation Guide

ManualsBrandsBlue Wave ManualsOutdoorsBelize 24 ft. Round 48 in. Deep 6 in. Top Rail Metal Wall Swimming Pool Package

UNIVERSAL INSTRUCTIONS

ROUND POOLS

PLEASE READ THESE INSTRUCTIONS CAREFULLY AND THOROUGHLY BEFORE

STARTING GROUND PREPARATION AND POOL ASSEMBLY.

DOING SO WILL PREVENT PROBLEMS.

Round Pool: General information ------------

1) Selection pool site ----------------------------

2) Ground preparation --------------------------

3) Assembling bottom rail ----------------------

4) Installing wall ----------------------------------

5) Build an earth mound (cove) --------------

6) Through the wall skimmer ------------------

7) Liner installation. ------------------------------

8) Install the Top Rail and Upper Joint ------

9) Filling the pool ---------------------------------

10) Helpfull information ---------------------------

11) SAFTY RULES --------------------------------

Page

Please refer to "Assemble TopSeat , Vertical and Cover" of an attached sheet.

Summary of content (6 pages)

PAGE 1
UNIVERSAL INSTRUCTIONS ROUND POOLS PLEASE READ THESE INSTRUCTIONS CAREFULLY AND THOROUGHLY BEFORE STARTING GROUND PREPARATION AND POOL ASSEMBLY. DOING SO WILL PREVENT PROBLEMS.
PAGE 2
GENERAL INFORMATION 1) SELECTION OF POOL SITE Before attempting to set up the pool, read the entire instructions. There are certain areas in the instructions that are extremely important to follow exactly as written and/or pictured. Any deviation from these instructions voids warranty of the pool and could cause bodily harm or damage to your property.
PAGE 3
2) GROUND PREPARATION The preparation of the ground is the most important step in the installation of the pool. Pool Dimension & Wall Length POOL SIZE a) Mark off your pool area by driving stakes. Have a helper hold a tape measure or a string and mark off the pool perimeter using flour or chalk. Remove sod inside the pool area to a distance of 1 feet beyond dimensions shown in the plot layout around entire perimeter of pool. Diameter mm.
PAGE 4
INSIDE OF POOL BOLT 4) INSTALLING WALL WALL Use Wall Joint Bolt Package packed in a Wall Carton. WALL NUT 3 / 8 REINFORCING WASHER φ 1 P.N.-0411 1/4in Reinforcing Washer 1/2 P.N.-0513 1/4 x 1/2in Truss Head Screw P.N.-0611 1/4in Nut DO NOT FASTEN THE WALL WITHOUT USING THE REINFORCING WASHERS ! FAILURE TO USE REINFORCING WASHERS AS INSTRUCTED WILL CAUSE WALL TO SPLIT WHEN POOL IS FILLED. THIS CAN CAUSE SERIOUS PROPERTY DAMAGE AND/OR BODILY INJURY.
PAGE 5
6) THROUGH THE WALL SKIMMER 8) INSTALL THE TOP RAIL,UPPER JOINT Step 1: Lay out these parts on the ground alternating upper joints and rails at the same position with the lower joints and bottom rails assembled before.Insert the top rail into upper joint,Clip a rail over the plastic edging and top of the wall as shown at right.. Clip all rails and upper joints over the wall in this way until the entire top rail is formed.
PAGE 6
10) HELPFUL INFORMATION 11) SAFETY RULES 1. 1. Read your instructions and safety rules carefully. If you do not follow the safety rules someone could be injured or damage could occur. 2. Plan carefully where you are going to put your pool. It must be close to a water source for filling. Also think about draining your pool. 3. Never let anyone swim alone. Children must be carefully watched. For added safety, install a convex type mirror above pool to give full view of interior.