Instructions / Assembly

Put cover bracket as shown in the figure.

Tighten up #12 Sheet Metal Screw.

Put Resin Upper Joint as shown in the Figure,

tighten up #12 Sheet Metal Screws.

Hook Assembled Resin Upper Joint over the

top rail. Secure the bottm of vertical to Resin

Lower Joint by #12 Sheet Meal Screws,

Continue installing verticals in this manner

All around the pool.

Place each of the top seat over the upper joints and secure

with

1 #12 Sheet Metal Screws.

Install all of top seat in this way around entire pool.

Top seat are installed between verticals.

Each end of top seat rest on upper joint and attached to it.

It may be necessary to move the complete verticals slightly

to left or right to accommodate the top seat.

Do this carefully as not disturb the earth mound, Check all

screws to be sure they are tight.

c ) INSTALLING TOP SEATS

b ) INSTALLING VERTICALS

a ) PRE-ASSEMBLING VERTICALS

P.No.0341

#12 Sheet Metal Screw

ASSEMBLE Top Seat, Vertical and Cover

6 FRAME

3/4

PAGE 1
ASSEMBLE Top Seat, Vertical and Cover 6 FRAME a ) PRE-ASSEMBLING VERTICALS Put cover bracket as shown in the figure. Tighten up #12 Sheet Metal Screw. Put Resin Upper Joint as shown in the Figure, tighten up #12 Sheet Metal Screws. 3/4 P.No.0341 #12 Sheet Metal Screw P.No.0341 #12 Sheet Metal Screw b ) INSTALLING VERTICALS Hook Assembled Resin Upper Joint over the top rail.
PAGE 2
d ) INSTALLING SEAT COVERS Attach seat cover by placing it from inside of pool in right position as shown in the figure. put seat cover and cover bracket together, Insert #12 Sheet Metal Screw from cover bracket to seat cover, and tighten it up. put #12 Sheet Metal Screw to seat cover and tighten it up. put seat cover cap on top of cover. P.No.2402.PP Seat Cover Cap 3/4 P.No.0341 #12 Sheet Metal Screw P.No.