Installation Guide

Do not start the installation of your pool unless you have
an entire day to finish the work.
Do not try to set up your pool on a windy day.
The wall will be difficult or even impossible to handle.
An average pool needs 2 or 3 people for
installation.
The following tools and materials are needed.
Shovel
Marking
Pencil
Masking
Tape
Rake
Chalk or
Flour
Plastic Tape
Earth Roller
String
Hammer &
Nails
Sand
2"x4" Board
Screwdriver
Tamping Tool
Pegs and
Stakes
Carpenter's
Level
Measuring Tape
Patio Block
Open the cartons and remove all parts except steel wall and liner.
Before pool assembly, you must identify, count and check all parts for
assembly by parts list. Familiarize yourself with all of the parts. Refer
to the parts list.
a) The site must be large enough to accommodate the pool with
plenty of area around it for pool accessaries, chairs, tables etc.
b) Determine where your filtration and skimmer will be located.
It must be connected to a grounded 110 volt electrical outlet,
with a G.F.I. (Ground Fault Interrupter)
c) The pool must be in reach of your water supply. Although the
water should not be drained, but kept clean through filtration and
chemicals, there should be drainage facilities near in case of need.
d) Perimeter area of ground must be absolutely level and firm. All
grass and sod under entire pool area must be dug out to avoid
unpleasant odors from decomposition under the pool due to lack of
air. Remove sharp objects, stones, twigs, pebbles, roots, etc.
They may damage the liner. If the ground has been treated with
chemicals or weed killer allow two weeks before setting up the pool.
Do not set up the pool on concrete, asphalt, tar paper, peatmoss,
sand, gravel, or where nut grass has been planted.
Poorly prepared ground could allow certain weeds or grass to grow
through the liner. Liner is not warranted against this. If ground is
uneven in perimeter area, dig out the high spots. Do not build up the
low side by padding it with earth. The weight and movement of the
water will pack down the fill causing the pool to sink. Inside
perimeter of pool (the area inside of the frame and wall) can be
leveled with 1" or 2" of sand raked and rolled smooth.
1) SELECTION OF POOL SITE
Before starting the installation, the following points are
important;
FAILURE TO OBSERVE ANY OF THE ABOVE INSTRUCTIONS
WILL VOID WARRANTY.
GENERAL INFORMATION
Before attempting to set up the pool, read the entire
instructions. There are certain areas in the instructions that are
extremely important to follow exactly as written and/or pictured.
Any deviation from these instructions voids warranty of the pool
and could cause bodily harm or damage to your property.
20' 6- 3/4" (48" Wall)
20'
6- 3/4" (48" Wall)
20'
10-3/4" (52" Wall)
20'
10-3/4" (52" Wall)
25x15
30x15
48" Oval Frame
(960mm)
(9198mm)
(7656mm)
(542mm)
25'
1-3/8"
15'
(4572mm)
(6269mm) (6370mm)
(4572mm)
15'
(6269mm) (6370mm)
30'
2-1/8"
3'
1-3/4"
1'
9-3/8"
SIFTED EARTH OR SAND NEEDED
PER EACH SIZE POOL AS FOLLOWS:
CAUTION:
16' x 12' 26 cubic feet 0.79cubicM
20' x 12' 34 cubic feet 0.96cubicM
24' x 12' 42 cubic feet 1.19cubicM
25' x 15' 54 cubic feet 1.53cubicM
30' x 15' 66 cubic feet 1.87cubicM
33' x 18' 87 cubic feet 2.46cubicM
41' x 21' 127 cubic feet 3.59cubicM
1
POOL SIZE Wall Length Top Sheet
mm ft in
.
Q'ty
1612 13,855 45 5 4/8 12
2012 16,364 53 8 2/8 14
2412 18,873 61 11 16
2515 20,625 67 8 14
3015 23,756 77 11 2/8 16
3318 26,586 87 2 6/8 18
4121 32,549 106 9 4/8 22