Installation Guide

23' 8-1/4" (48" Wall)
24'
1/4" (52" Wall)
a) Mark off your pool area
by driving stakes. Have a
helper hold a tape measure
or a string and mark off the
pool perimeter using flour
or chalk. Remove sod inside
thepoolareatoadistance
of 1 feet beyond dimensions
shown in the plot layout
around entire perimeter
of pool.
The preparation of the
ground is the most
important step in the
installation of the pool.
b) Remove all grass from
within the entire pool area.
It is not enough to just cut
the grass. The sod must
be removed.
c) Two or three inches of sand is the best for your liner. Using sand eliminates the necessity to level inside of frame area except where
exceptionally high or low areas exist.
These areas should either be dug or filled in. This does not mean the perimeter or frame area. That area must be firm and level by digging
only.
d) Do not fill low spots in the area where pool wall will rest. as setting may cause your pool to become out of level.
Making sure pool bottom is flat.This is a must.
e) If your site is not on firm soil, use 2" patio blocks for the base of the wall Care should be taken to center a patio
block under each bottom plate. The top of the patio blocks should be flush with the prepared ground surface.
2) GROUND PREPARATION
26' 9-1/4" (48" Wall)
27'
1-1/4" (52" Wall)
17'
6-7/8" (48" Wall)
17'
10-7/8" (52" Wall)
17'
10-7/8" (52" Wall)
17'
10-7/8" (52" Wall)
17'
6-7/8" (48" Wall)
17'
6-7/8" (48" Wall)
24x12
52" Oval Frame
33x18
41x21
20x12
(575mm)
(1011mm)
21'
(6401mm)
41'
2-7/8"
(4847mm)
15'
10-7/8"
(6083mm)
19'
11-4/8"
(12570mm)
(10112mm)
33'
2-1/8"
1'
10-5/8"
24'
1/8"
(7319mm)
3'
3-3/4"
(3611mm) 11'
10-1/8"
(5355mm)
(5487mm)
(5456mm) (5355mm)
(8161mm)
(3611mm)
(8262mm)
(7220mm) (7321mm)
(5355mm)
(3611mm)
(5456mm)
11'
10-1/8"
(5456mm)
11'
10-1/8"
18'
16x12
2