Installation Guide

7
P.No.0923
P.No.0923
M8 x 20 Hex Head Bolt
M8 x 20 Hex Head Bolt
P.No.0623
P.No.0623
M8 Nut
M8 Nut
Top seat temporally placed should be removed before
proceeding to next step.
Note:
All Bolts to be inserted from the top side, Nuts to be
inserted from undernerath Tension straps.
6) POSITIONING ASSEMBLED OVAL PARTS
.
Put Pressure plate by Using #12
SheetMetal Screw after Positioning
Assembled oval parts.
Set all oval parts on the right position, Check(A)
length(distance between horizontal supports). Put
top seat on top of side upper joint temporally as
shown figure. Then check a-b,c-d is straight and
level. if not, adjust accordingly.
This end should be connected
to horizontal support.
End strap
End strap; 7224 . Those should be used for the end.
Middle strap; 7254, 7244, 7264 or 7285. Those should be
used for the middle.
Connect type(B) strap(s) to already assembled type(A) straps.
using five sets of M8x20mm hex headed bolt and M8 nut.
Use #0106.PACK Strap Bolt Package
Use #0105.PACK Strap Bolt Package
5) CONNECTING TENSION STRAPS
Middle strap
P.No.0341
#12 Sheet Metal Screw
7224 - 2pieces 33x18 - 3straps.
7264 - 2pieces
7224 - 2pieces 41x21 - 4straps.
7285 - 3pieces
7224 - 2pieces 16x12 - 1straps.
7254 - 1pieces 20x12 - 2straps.
24x12 - 3straps.
7224 - 2pieces 25x15 - 2straps.
7244 - 2pieces 30x15 - 3straps.
Quantity per set. Number of sets per pool.
12' Base Oval Pools
15' Base Oval Pools
18' Base Oval Pools
21' Base Oval Pools
Combination of Strap Set
Length of Tension Straps.
Parts No. Type Length(in) Length
(mm)
7224 End 55-1/8" 1400
7254 Middle 32-7/8" 835
7244 Middle 36-5/8" 929
7264 Middle 55-2/8" 1405
7285 Middle 50-5/8" 1286
20mm
P.No.6254
Pressure plate
Pool Size (A)Length
(in)
(A)Length
(mm)
16x12 4' 5/8" 1236
20x12 4' 5/8" 1236
24x12 4' 5/8" 1236
25x15 5' 1/4" 1530
30x15 5' 1/4" 1530
33x18 5' 1/4" 1530
41x21 5' 1/4" 1530
List of (A) Length
3/4
b
d
a
c
Note:
As shown below, put concrete block underneath the outside
of horizontal support assembled.