Instructions / Assembly

Put Resin Upper Joint as shown in the
Figure,tighten up #12 Sheet Metal
Screws.
Hook Assembled Resin Upper Joint
over the top rail. Secure the bottm of
vertical to Resin Lower Joint by #12
Sheet Meal Screws, Continue installing
verticals in this manner
All around the pool.
Place each of the top seat over the upper joints and
secure with #12 Sheet Metal Screws.
Install all of top seat in this way around entire pool.
Top seat are installed between verticals.
Each end of top seat rest on upper joint and
attached to it.
It may be necessary to move the complete verticals
slightly to left or right to accommodate the top seat.
Do this carefully as not disturb the earth mound,
Check all screws to be sure they are tight.
c ) INSTALLING TOP SEATS
a ) PRE-ASSEMBLING VERTICALS
b ) INSTALLING VERTICALS
P.No.0341
#12 Sheet Metal Screw
ASSEMBLE Top Seat, Vertical and Cover
7 FRAME
PERMANET INJURY OR DEATH CAN RESULT.
ALL THESE POOLS ARE DESIGNED FOR SWIMMING ONLY.
THEY MUST NOT BE USED FOR JUMPING OR DIVING.
DIVE
DO NOT
JUMP
DO NOT
P.No.0341
#12 Sheet Metal Screw
3/4

Summary of content (2 pages)