Installation Guide

4
Connect brase to horizontal support. Washer from outside then put M8 nut Put M8x20 hex head bolt with Plain from inside, Do not fasten tightly. STEP4; Fasten all bolts and screws tightly. M8x20 hex head bolt.- two sets each for side vertical to horizontal support, brace to side vertical and brace to horizontal support. #12 Sheet Metal Screw two sets each for braceto side vertical.
P.No.0923
P.No.0923
P.No.0923
M8 x 20 Hex Head Bolt
M8 x 20 Hex Head Bolt
M8 x 20 Hex Head Bolt
P.No.0623
P.No.0423
P.No.0423
P.No.0623
M8 Nut
M8 Nut
P.No.4105 Brace For 48" P.No.4106 Brace For 52"
P.No.7224 End Strap
Plain Washer
Plain Washer
P.No.5238 Horizontal Support For 48" P.No.5239 Horizontal Support For 52"
STEP3;
P.No 3234 Resin Side Lower Rail Joint (5/8in Rail) P.No.3223 Resin Side Lower Rail Joint (1in Rail)
20mm
M8 x 20 Hex Head Bolt P.No.0923
M8 Nut P.No.0623
3-1) ASSEMBLING TENSION STRAP.
STEP;5 Refer page-7 "5) Connecting tention straps." Attach End strap to Holizontal support, Put to determine kind of straps. M8 Nut from bottm. Put all bolt and tighten up. M8x20 hex head Bolt from top and put
P.No.0623 M8 Nut
Plain Washer P.No.0423
STEP1
STEP4
STEP3
#12 Sheet Metal Screw P.No.0341
3/4