Instructions / Assembly

STEP 3
STEP 3 CONT.
4
• Place washer on bolt and insert from INSIDE of
ladder thru leg and step connector. Insert a
second washer on end of bolt and screw on
nut. Do not over tighten.
• Repeat above steps for the right step connector
with the remaining bolt, washers and nut.
• To attach step connectors to steps, secure with
(2) #10 x 1/4” screw through each pre-marked
openings on the step connectors into steps on
left and right sides.
• Once completed set this half of the ladder aside
and proceed to STEP 4
• Locate step connectors (E) which will be
installed to hold the steps in place. There is a
right and a left step connector, they are NOT
interchangeable. The angle of the connector
will allow for installation on only ONE side of
the steps. Check the top of the connectors for
the raised left and right markings.
• Line up rounded area of left step connector
with predrilled hole at top of leg. Remember,
only one of these connectors will fit properly
on the left side.