Full Product Manual

HOW TO...
ADJUST INTAKE PORT HEIGHT
ENSURE POOL COVERAGE & PREVENT CABLE TANGLING
RETRIEVE CLEANER FROM POOL
Axle
Position
Axle
Position
Axle
Position
Axle
Position
To change the angle and direction of the cleaning path
simply alternate the pins located underneath the bottom
of the cleaner. We recommend to change the direction
every cleaning cycle to ensure the cleaner is covering the
whole pool as well as to prevent cable tangling.
Should you need to lower the suction points on the cleaner you may adjust
the valves underneath the cleaner by flipping it over to locate the valves
as noted in the illustration. Use a phillips head screwdriver to loosen the
screw and lower the valve to the desired position. Should your cleaner hit
low lying obstacles, just raise the valves up as needed.
Should your cleaner have a Swivel:
Grab cable between the cleaner
and swivel. DO NOT grab swivel
GENTLY pull the cable
and bring the cleaner
toward you.
Lift cleaner by using the handle
attached to the cleaner.
DO NOT lift cleaner by the cable.
Fixed Pin
Adjustable Pin
1
2 3
CLEAN THE FILTERS
1
ALL MODELS
Push tabs down and
outward. This will remove
the cover and expose the
filter *bags.(*Select models
have baskets)
2
FILTER BAG MODELS
Remove filter bags from
inside cleaner by gently
pulling on the elastic band
around the suction ports.
Turn bag inside out.
3
FILTER BAG MODELS
Pull tabs to undo Velcro®
and turn the filter bag inside
out to ensure a
thorough cleaning.
2a
FILTER BASKET MODELS
Press in tab on side of
basket to expose the inside
of the compartment.
4
ALL MODELS
Use a garden hose to clean
filter bag / basket.
We recommend cleaning
the filter bags after
every cleaning cycle.
ENG ESP FRA DEU ITL POR