Full Product Manual

EXTEND THE LIFE OF YOUR CLEANER
Your pool cleaner does a lot of work behind the scenes during the season. To help you get the most out of your product, we’ve listed some important
tips on how to extend the life of your pool cleaning investment. Take care of your robot and it’ll take care of you.
TIP #1: DO NOT DROP THE UNIT OR POWER SUPPLY!
Dropping your cleaner or power supply will cause damage and
your robot will not work properly.
TIP #2: CLEAN THE FILTER BAGS!
Make sure to clean your robot’s filter bags or baskets! Cleaning
these keeps your robot running smoothly, quickly, prevents
clogging, and keeps re-circulated water crystal clear!
“My robot isn’t picking up debris...” - Clean. The. Filter.
TIP #4: GIVE IT A RINSE
After use, remove your Aquabot from the pool and rinse the
outside AND inside thoroughly. Doing so will help prolong the
life of the product by rinsing off any pool water that probably
contains chlorine. Rinse off its internal components as well.
Note: It is recommended to leave the cleaner in the pool for 20
minutes after each cycle to let the motor cool down properly.
TIP #5: STORAGE WHEN NOT IN USE
DO NOT leave your cleaner in the pool when not in use! Store it and the power supply
in a dry / shaded area. Coiling the floating cable underneath the cleaner helps keep
the integrity of the cable. A shaded area prevents any prolonged exposure to the hot
summer heat. Removing the cleaner from the water prevents any over-exposure to
pool water during the swimming season. Even whales come up for air once in a while,
so should your pool cleaner. If storing your cleaner in a box, make sure cleaner is dry.
During the winter months it is important to make sure your cleaner is completely dry
and kept at proper storage temperatures ranging from 10ºC – 40ºC (50ºF – 104ºF).
This will keep the motors, plastics and seals protected.
TIP #3: POOL COVERAGE / PREVENT CABLE TANGLING
Your cleaner is equipped with an adjustable pin / axle option.
Adjust it in the opposite direction after every cleaning cycle.
This will ensure your cleaner reaches all areas of the pool and it
really helps to prevent cable tangling. “My cable keeps getting
tangled...” - Adjust the pins / axle configuration.
ENG ESP FRA DEU ITL POR