Instructions / Assembly

STEP 1

• Using Phillips head screwdriver, remove the closure clamp (D) from the valve assembly.

You only

need to unscrew one side completely as it can be removed and reinstalled without unscrewing

both screws

• Remove the valve (C) from the tank and place it to the side until instructed to reattach it.

ASSEMBLY INSTRUCTIONS

FOR SAND FILTER

• Inside the tank you will find the standpipe (E) and

a plastic bag containing the laterals (F).

• Attach lateral to standpipe by pushing into opening

and turning to the right as shown above.

• Repeat for remaining seven laterals.

NOTE

Filter is partially assembled; however, nothing has been properly

tightened. DO NOT operate filter system without completing

assembly instructions.

NOTE

You MUST install the laterals on the

standpipe INSIDE the tank as the

standpipe will not fit back through the

opening once laterals are attached.