Owners manual

STEP 2

• The filter and pump should be attached to the base prior to filling the filter with sand as it

will be difficult to maneuver after the tank is full.

• In order to attach your pump to the base, determine which of the two pumps shown below

is most like your pump and follow the corresponding instructions for installation to the base.

A. CRADLE STYLE MOUNT

• Pumps with cradles located directly under the motor

should be aligned with the holes on the base in the

raised area where the six holes are close together.

This type of mount will require the use of two to four

mounting bolts from the hardware supplied with the

base.

• Line the pump up with the set of holes which are the

best fit for the pump and bolt in place.

• Proceed to STEP 3.

B. PLASTIC PUMP HOUSING MOUNT

• Pumps with plastic pump housing mounts should be

attached by aligning the openings with a set of the

OVAL shaped holes which are towards the center of

the base. This type of mount will require the use of

TWO mounting bolts from the hardware supplied with

the base.

If you are attaching a Speck SS E90 or SS E91

pump, use the larger oval holes towards the back

of the base.

• Bolt the housing of the pump through the base and

tighten.

• Proceed to STEP 3.