Owners manual

STEP 3

• Before filling tank with sand, cover

standpipe with a plastic bag to prevent sand from

entering standpipe. Secure in place with rubber

band so it does not fall off.

•

Once bag is secured, place standpipe in the bottom of

the sand tank. Make sure pipe is centered in tank

BEFORE pouring sand into tank because you will

NOT

be able to move it once sand is in.

• Clear plastic tube attached to standpipe is an

air relief. As you are adding the sand into the

tank, try to hold the tube up against the stand-

pipe. The white piece on the end of this tube

should be ABOVE sand level when you are

done adding sand to the filter.

NOTE

If the drain plug is not lined up with the third arrow OR it lifts

off the base, retry the aforementioned steps to properly

attach tank to base.

NOTE

DO NOT pull too hard when holding up air relief tube, if you

pull it off the bottom of the standpipe, sand will be able to

enter your pool through the hole.

NOTE

Sand should be filled no less than 1/2 way up the tank and no more

than 3/4. Over-filling will result in permanent damage to your

Filter System.