Owners manual

STEP 4

• Locate o-ring (G) on bottom of 6-way valve (C).

• Lubricate with o-ring lube to ensure proper seal

on tank.

• Push o-ring against the lip of the valve. It MUST sit

flat against the lip to protect from leaking at the valve.

• Clean off any sand or debris on top lip of filter and

position valve over the opening of the standpipe.

• Valve will slide ONTO standpipe when positioned

properly in tank (as shown). Push down firmly to

make sure valve slides on all the way.

NOTE

You CANNOT pull standpipe up to secure

the valve. Pulling up can damage the

laterals and cause sand to get sent back

with water flow to pool.

• Add filter grade sand (sold separately) to

filter tank around standpipe. The approximate

amount of sand necessary will vary based on

the size filter you purchased.

18” Tank .... 110 Lbs.

22” T

ank .... 220 Lbs.

26” T

ank .... 360 Lbs.

• Remove plastic bag and fill tank with water until the tank is filled right below opening

of standpipe.

NOTE

NEVER FILL SAND TANK MORE THAN 1/2 TO 3/4 OF THE WAY.

Adding too much sand can cause weak return flow.

STEP 3 — CONTINUED