Owners manual

STEP 5
• Once valve is in place, hold clamp (D) as shown and
position clamp around lip of filter and over edge of
valve.
• The clamp should sit flat around the lip of the tank
and valve. If it is not sitting flat the clamp will leak.
• Make sure that the screws of the clamp are lined
up with the seams of the tank. Tighten two screws
on clamp a little at a time. Alternating from side to
side so that both sides are tighten equally
.
Failure to follow these instructions will result in
a leak at the clamp.
• Cover threads of pressure gauge (I) with Teflon
tape (K) and thread into the open hole on the
valve and hand tighten only
.
8