Use and Care Manual

REMOVE DEBRIS AND WATER
Remove standing water and debris from your pool cover before removing the cover itself. The cover should
be cleaned and dried thoroughly before it is put away. Store cover in a clean, dry place away from sunlight.
CHECK WATER LEVEL
If the water level is below the middle of the skimmer face, ll the pool water to the proper level, usually about
half way up the skimmer. With your leaf skimmer, remove any oating debris.
CHECK FILTRATION SYSTEM
Make sure all mechanical equipment is operating properly. Check for leaks in exposed piping, tighten loose
ttings, and make all needed repairs. Start the lter and vacuum your pool if necessary.
TEST THE WATER
After running the lter for several hours, test the water with your test kit or take a water sample to your
professional pool dealer for analysis. The most critical tests to perform are those for stabilizer, alkalinity, pH,
and chlorine. It is a good idea to purchase fresh reagents for your test kit each season to avoid possible
inaccurate test readings. Incorrect additions of chemicals to your pool could be wasteful and costly.
ADD CHEMICALS
Based on the reading of your test kit or the advice from your local dealer, add the necessary chemicals to the
pool water. ADD CHEMICALS FROM START-UP KIT FOLLOWING LABEL DIRECTIONS. REMEMBER TO ALWAYS
FOLLOW THE DIRECTIONS ACCORDING TO YOUR POOL’S SIZE AND CAPACITY.
ROUTINE MAINTENANCE
Once your pool has been opened, it is crucial that you keep it in the best condition. During the summer
season, pool water can be aected by a variety of factors. Rain, wind, hot and humid weather, and heavy
usage can aect chlorine and pH levels. It is very important to test the water often so you can determine
what to add to your pool to keep it clean and crystal clear.
Your lter should run as much as necessary to keep the pool clear. We recommend at least 8-12 hours a day.
Chemicals and proper ltration work hand-in-hand to keep your pool clean and safe for swimming.
Remember to SUPER CHLORINATE at least once every two weeks using Blue Wave’s Burst shock. This will
help to ensure a trouble-free season by burning o impurities in the water and freeing up the chlorine to
handle its very important role of sanitizing the water.
As outside conditions change so to will your pool’s needs. Correct small problems before they become big
ones and you will enjoy a trouble-free season.
START-UP KIT & OPENING INSTRUCTIONS
Opening your pool correctly is quite important. Provided below is a step-by- step
checklist to help you do it right. Following the procedures below will put you
well on your way toward an enjoyable swimming season!