Installation guide

BN-905GR Bluetooth GPS Receiver

BN-905GR Quick Installation Guide

Thank you for purchasing BN-905GR 51-Channel Bluetooth GPS Receiver. It supports ultra high

sensitivity GPS navigation and supports Smart Power control for power saving.

Main features:

z Acquires 51 satellites all in view in parallel and ultra low power consumption

z Personal/Portable Navigation (PDA, Pocket PC, Laptop, etc.)

z Smart power control – Auto detecting On-Off function for power saving

Fast Acquisition Rate within 1 seconds for hot start and 36 seconds for cold start.

Superior sensitivity -158dBm for urban canyon and foliage environment

Navigation time up to 25 hours in continuous mode

Bluetooth V1.2 SPP profile with operation range 10 Meters

WAAS/EGNOS Enable.

A. Standard Package

GPS Unit BN-905GR (1) + Lithium-ION Rechargeable Battery (2) + Cigarette Adapter (3) + Travel Charger (4) + Quick Installation Guide.

(* Travel Charger plug type might be adjusted according to corresponding countries.)

(*The Cigarette Adapter can only be used to charge BN-905GR. Please don’t make use of it with devices other than BN-905GR.)

1. 2. 3. 4.

B. Appearance

1. Power jack (mini USB type)

2. Power switch

3. Battery status LED (Red/Green)

4. Bluetooth status LED (Blue)

5. GPS status LED (Orange)

6. Internal antenna

C. Battery installation

C-1 Put Battery in place: Press the PUSH button on the bottom side of the unit (1) and pull out the battery cover. Insert battery in the

unit (2) and put battery cover on to the cabinet (3), then push down and force it forward to fit firmly (4).

1. 2. 3. 4.

C-2 Take Battery out: Press the PUSH button on the bottom side of the unit (1) and pull out the battery cover (2). Then take out the

battery from the unit (3).

1. 2. 3.

D. Charging your battery

E. Start to use

E-1 Fully charge the battery when using at the first time

A fully charged battery can last up to 30 hours continuously operation.

For the first time using the BN-905GR, please charge battery until it is fully

charged. Take the power cable and connect it to the power jack (mini USB

type) and recharge through travel charger or car cigarette adaptor. This will

begin to charge the battery. Charging time is 3 hours typically.

- When the Power LED is Red, battery power is low status. Please recharge.

- When the Power LED is Green, the battery is under charging mode.

- When the Power LED is blinking, the battery is fully charged.

PAGE 1
BN-905GR Bluetooth GPS Receiver BN-905GR Quick Installation Guide Thank you for purchasing BN-905GR 51-Channel Bluetooth GPS Receiver. It supports ultra high sensitivity GPS navigation and supports Smart Power control for power saving. Main features: z z z z z z z z Acquires 51 satellites all in view in parallel and ultra low power consumption Personal/Portable Navigation (PDA, Pocket PC, Laptop, etc.
PAGE 2
Next Generation GPS 51-Channel Bluetooth GPS BN-905GR Quick Guide E-2 Activate the Bluetooth function in your PDA/Smart phone or PC Before activating the Bluetooth function in your PDA/PC, please switch on BN-905GR Receiver for paring and check if your device is equipped with Bluetooth function. If not, you may need to acquire an optional CF/SD Bluetooth card or Bluetooth dongle. NOTE: The pairing procedure is required to execute in the first time only. And the pass code is “0000” if required.