Bluetooth Headset User Manual

X5i Stereo Bluetooth Headset

Switching the Headset ON/OFF

z To switch on the Headset, click and hold ON/OFF for 3-4 seconds until

LED flashes blue rapidly and then release button.

z To switch off the Headset, click and hold ON/OFF for 3-4 seconds until

LED flashes red rapidly and then release button.

Pairing Headset with Bluetooth Devices (Phone, PDA)

z Before pairing the X5 Headset with Bluetooth Devices, please make

sure the host device supports any of the following profiles : A2DP,

AVRCP, Headset/Handsfree profiles.

z With battery mounted onto Headset, click and hold Vol Up & ON/OFF

buttons together for more than 4 seconds. When LED starts to flash red

and blue alternately, release the two buttons. LED will then flash red

and blue continuously. This pairing mode will last for 1 minute and if no

pairing is made within this period, the Headset will return to standby

mode.

z Manipulate the buttons or menus of Bluetooth device to complete

pairing (Refer to device’s manual as the instructions may differ from

device to device). Check if X5 Stereo or corresponding ‘Bluetooth

Address’ is displayed in the list of searched devices. If device is not

found, repeat pairing procedure.

z When prompted to enter PinKey, enter 1234 which is the fixed PinKey

for X5 Stereo Bluetooth Headset.

z The Headset can be paired with up to 10 different devices. Pairing is

done just once and not every time a different device is used.

z For pairing of Headset with Audio Streamer, refer to the instructions on

page 15.

This following is an example of how to pair with your phone/PDA. This

procedure may differ depending on the mobile phone you’re using.

1.Put your X5 Stereo into Pairing mode as above.

2.Turn Bluetooth ON in your mobile phone or PDA(Refer to your Phone

User Guide) and perform a device discovery to Search/Add the X5

3.When devices are displayed, select the X5 Stereo. Enter Passkey “1234”.

4. Set the X5 Stereo as a trusted/authorized device, if it is an option in your

phone.

5. Finish and exit. (Refer to your Phone User Guide for any additional steps)

6.To pair up more devices; Repeat steps 3-6 for each device you want to

pair.

Note: Some devices require you to pair once for High Quality Audio/A2DP

profile and again for Handsfree/Headset profile, E.G HP 6515. Other

phones require pairing only once but will enable both profiles E.G Samsung

D600, O2 XDA Atom)