User's Manual

BM-150R Series Manual

Install/Remove the Battery4

We strongly recommend that you use the adapter which was purchased with the product for charging the battery.

However, the 24 pin charger of an ordinary mobile phone may also be used to charge the PDA battery. (Due to the

characteristics of a standard charger, there may be small discharge of electricity despite the charger being fully charged.)

[Install the Battery]

1. Put the battery in line with the

left part of the PDA and then

push the right part to lock.

2. Put the projected part of the

cover on top of the groove in the

back and then push carefully

with both thumbs.

[Remove the Battery]

1. Push down using both thumbs to

remove the cover.

2. Raise the battery by using the

groove on the lower part to

remove the battery.

MiniSD Memory Card5

Make sure that the gold plate terminal of the memory card

is pointed towards the back when inserting into the MiniSD

slot. For removal push the exposed part of the memory

card. It will pop out.

Frequent insertion/removal of the memory

card, or applying too much force to it, may

cause the product to malfunction.

Card removal and turning the power off/on

using the memory card may result in loss of

data or cause the memory card and PDA to

malfunction.

Important data should always be saved on the

computer. The company will not take any

responsibility for the loss of data on this

product.

If the memory card cannot be removed easily,

instead of removing it with force, inquire to

the service center for its removal, or ask for an

exchange or refund of the product.

IIII.. UUnnddeerrssttaannddiinngg YYoouurr PPhhoonnee