Operating instructions

SEEDER ASSEMBLY

WARNING!

DO NOT use or start the engine until the

seeder is in place.

1. Remove rear cover, it is not used with the

seeder attachment.

2. Place a block of wood under the rear frame to

support the unit when the rear wheels are re-

moved.

3. Remove the two (2) retaining rings on the rear

wheel (they are not reusable, new rings are in

the kit). Remove wheel from rear axle.

4. Loosen one (1) set screw on the locking collar.

Using a punch loosen the locking collar on the

rear axle. Do the same on the other side.

5. Remove bolts holding the bearings to the frame.

6. Remove rear axle from unit. The wheel that is

pinned to the axle can remain on the axle.

7. Remove push nut (push nut is not reusable, a

new one is in kit) from the right side of the rub-

ber flap rod. Lay the rubber flap away from the

right side so the cable can run between the flap

and frame.

8. Route the cable from the seed gate between

the bottom of the frame and the top of the rub-

ber flap. See Figure 1.

FIGURE 1

9. Place seed box on unit, replace bearing with

eccentric collar to the outside. The screws that

attach the seedbox to the frame MUST have

washers inside the seedbox on the screws. DO

NOT overtighten and smash plastic, snug-up

ONLY. See Figure 2.

FIGURE 2

NOTE: Do not tighten hardware on the bearings until

the axle is installed.

Assembly directions, Seeder

(Part No. 107179)