User's Manual

Safety and Handling 11
This device was tested for typical body-worn operations with the back of the handset
kept 0.39 inches (1cm) between the user’s body and the back of the handset.
To comply with FCC RF exposure requirements, the handset must be kept
0.39 inches (1cm) from the body without any reference to a particular side or edge.
Any beltclips, holsters, and similar accessories containing metallic components may not
be used.
Body-worn accessories that cannot maintain 0.39 inches (1cm) separation distance
between the user's body and the handset, and have not been tested for typical body-
worn operations may not comply with FCC RF exposure limits and should be avoided.
Part 15.105 (B)
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications, However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Modifications not expressly approved by the manufacturer could void the user’s authority
to operated the equipment under FCC rules.