Use and Care Manual

38
MAINTENANCE
Removing and refitting the wheels
To remove the left wheel (8) from the stump grinder,
remove the locking collar (9), the 1/4” screws (10),
the 1/4” hex nuts (3), the springs (4) and the brake
pad (7). The wheel can now be removed from the
axle.
To remove the right wheel (2), remove the locking
collar (1) and slide the wheel off the axle.
8011-217chg
LEFT
RIGHT
FRONT
WARNING!
The cutters can come loose from the
cutting wheel if the screws are not
sufficiently tight. Comply with the
recommended torque settings.
Cutting Wheel
Tighten the bolts to 30 ft/lbs. (40.67 Nm).
NOTE: The cutter teeth each have three cutting sides.
Individual teeth may be repositioned twice before
replacement is necessary.
Tooth Cutter
(Carbide Face)