Installation Guide

ManualsBrandsBluefall ManualsRefrigerator Water FiltersFridgePod 3-Pack 12-Month Refrigerator Water Filter

This Refrigerator Filter Cartridge is Tested

and Certified by NSF International against

NSF/ANSI Standard 42 for materials and

structural integrity requirements.

NSF

Certified by IAPMO R&T against NSF/ANSI

Standard 42 for materials safety, structural

integrity and aesthetic chlorine reduction

when used in the BF-GE-MWF-S

This system has been tested according to NSF/ANSI 42 for the reduction of the

substance listed below. The concentration of the indicated substances in water

entering the system was reduced to a concentration less than or equal to the

permissible limit for water leaving the system as speciﬁed in NSF/ANSI standard 42.

Performance Data Sheet

Replacement Filter - BF-GE-MWF-S

Contaminant

Reduction*

Average

Inﬂuent

NSF Speciﬁed

Challenge

Concentration

Avg.%

Reduction

Average

Product Water

Concentration

Max Permissible

Product Water

Concentration

NSF Reduction

Requirements

Chlorine

Taste and Odor

2.1 mg/L

2.0 mg/L ± 10%

96.90%

0.1 mg/L

N/A

≥ 50%

Tested at a ﬂow rate of 0.5 gpm to a capacity of 300 gallons for the reduction of Chlorine, Taste and Odor.

For Residential Use Only

To reduce the risk associated with ingestion of contaminants:

To reduce the risk associated with property damage due to water leakage:

Installing the Filter Cartridge

^The replacement component BF-GE-MWF is ^compatible with the following absolute or alternate ﬁlter part numbers:

Service Flow

46 9991 46 9996 46 9904 46 9014 MWF WF40

WF4010

WF-401P

WF-401S

WF-401T

WF30

WSA-1

GERF-100

HWF

MWF3PK MWFA MWFAP MWFD S MWFINT WF401

12527304 04609904000 09904 09904P 123 19801 WF401P

12388401 12388402 12388403 12388406 12388407 WF401S

12527301 12527302 12527303 12527305 12527307 WF401T

12527309 12527504 46-9904 46-9904P 4609904000 WF287

Water Supply

Water Pressure

Water Temperature

0.5 gpm/(1.9 lpm)

Potable Water

30 -100 psi (207 – 689 kPa)

34 F - 100 F (1 C - 38 C)

For optimum performance, it’s recommended you change your ﬁlter every 6 months(Depends on water quality and level of contaminants)

A. On models without a replacement indicator light, apply the 6 month reminder sticker to the new cartridge and mark your calendar.

B. To remove, turn to the left about 1/4 turn.

C. Insert new ﬁlter and slowly turn the ﬁlter to the right (about 1/2 turn) until it stops.

D. Run water from the dispenser for 3 minutes (about 1 1/2 gallons) to clear the system and prevent sputtering.

E. Reset the indicator light (on models with this feature): Press and hold the RESET WATER FILTER pad on the dispenser for 3 seconds until

the light goes off or turn green.

469904 469904P 67003634 9904 9904P SGF-G1

AP4310541 PS1965106 WF-30 WF-40 WF-401 WSG-1

HWFA AP3859302 AP3967843 GWF GWF01 GWF06 GWFD S

WR02X11020 WR02X11287 WR02X11290 WR17S12 WR2M3552 PC40677 GWFA

PC61278A PS98 1638 PS983115 PT11577906 RWF0600A

*All trademarks remain the property of their respective holder(s) and are used for compatibility information only.

^Claimsofcompatibilityveriﬁedthroughmanufacturertesting.

A.Read and follow Use Instructions before installation and use of this system.

B.Installation and use MUST comply with all state and local plumbing codes.

C.Protect from freezing, remove ﬁlter cartridge when temperatures are expected to drop below 34℉(1℃)

D.Do not install systems in areas where ambient temperatures may go above 110℉ or below 40℉

E.Do not install on hot water supply lines. The maximum operating water temperature of this ﬁlter system is 100℉(38℃)

F. Do not install if water pressure exceeds 100psi. If your water pressure exceeds 80psi (552kPa), you must install

a pressure limiting valve. Contact a plumbing professional if you are uncertain how to check your water pressure.

G.Do not install where water hammer conditions may occur. If water hammer conditions exist you must install a water hammer arrester.

Contact a plumbing professional if you are uncertain how to check for this condition.

H.Where a backﬂow prevention device is installed on a water system, a device for controlling pressure due to thermal expansion

must be installed.

I. The disposable ﬁlter cartridge MUST be replaced every 6 months, at the rated capacity or sooner

if a noticeable reduction in ﬂow rate occurs.

Do not use with water that is microbiologically unsafe or of unknown quality without adequate

disinfection before or after the system.

COMPONENT

Summary of content (2 pages)

PAGE 1
Replacement Filter - BF-GE-MWF-S Performance Data Sheet This system has been tested according to NSF/ANSI 42 for the reduction of the substance listed below. The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system as specified in NSF/ANSI standard 42.
PAGE 2
Replacement Filter - BF-GE-MWF-S Frequently Asked Questions Do these filters have an expiration date? No. All of the filters we manufacture can sit on your shelf until you need them. We recommend a cool, dark, dry location. How do I know if my fridge has a built-in filter? Fridges with built-in water filters are usually side by side models with built-in ice and water dispensers. If you have a fridge like this then you should look for the filter in one of three places. A.