User manual

Page 18
www.bluenetvideo.com
BlueNet Video 888-616-1514
After entering the correct TCP/IP settings you will be ready for “Port Forwarding” (Cases A, F, and G).
Please record the TCP/IP settings of your NVS for future reference. You may need this information to
access your NVS and to configure “Port Forwarding”. In Case F, please contact your ISP with regard
to Port Forwarding
NVS TCP/IP Configuration
Internet Address
Subnet Mask
Default Gateway
Primary DNS Server
DDNS Server
Web Server Port
Video Server Port
After clicking “Apply” the system will prompt for a reboot. Please allow the system 30
seconds to reboot and accept the changes. After 30 seconds, close the configuration screen.
The view will display “Trying to Reconnect”. If the ACTIVE light on the NVS has went off
and is now back on again flashing, then the NVS has rebooted. After the system reboots
completely, remove the power supply from the unit and close Internet Explorer.
Return your PC/Laptop TCP/IP properties to their original settings.
Before installing the NVS, you must use “Port Forwarding” on your personal router (Cases A, F, and
G).
You will need to forward 2 ports: the Web Server Port you assigned to the NVS
the Video Server Port you assigned to the NVS
Both of these ports will be forwarded to the IP address you assigned to the NVS.
In the example above, you would forward: 8888 192.168.0.200
7777 192.168.0.200
***for information on how to use “Port Forwarding” please read Appendix C