User Guide

VXi BlueParrott
®
B350-XT User Guide PAGE 9
GETTING STARTED
On/Off/Standby
Turn Headset On: Hold down the MFB for approximately 2-3 seconds until you hear a voice prompt,
“Power on.” The red light will flash once every second.
Turn Headset Off (conserves battery power): Hold down the MFB for approximately 4–5 seconds until
you hear a voice prompt, “Power off.” A red light will flash 4 times and the headset will turn off.
Standby Mode: Once the headset is turned on (after the initial pairing), it will attempt to connect to the
last device that it was paired with, putting itself into Standby Mode.
Pairing with a Phone
NFC (One-Touch) Pairing
1. Make sure that NFC is enabled on your cell phone.
2. Place the NFC zone of your cell phone against the NFC zone
of the headset and hold together until your cell phone
confirms pairing is successful.
Note: NFC and One-Touch Pairing are dependent on your cell
phone. The size and sensitivity of your phone’s NFC zone and how
to connect the headset may vary between devices.