User Manual

BlueParrott S450-XT User Manual
PAGE 7
GETTING STARTED
Power S450-XT On/Off (Bluetooth Mode)
On: Slide the switch up toward the headband. The LED will flash blue three times and
you will hear a voice prompt, “Power on.” If your S450-XT is not already paired with a
device, it will automatically go into pairing mode; otherwise, it will attempt to connect
with its paired device(s).
Off (conserves battery power): Slide the switch down from the headband. The LED
will flash red four times and you will hear a voice prompt, “Power off.”
Standby Mode: Once the S450-XT is turned on (after the initial pairing), it will attempt
to connect to the last device that it was paired with, putting itself into Standby Mode.
How to Connect
NFC Pairing to a Bluetooth Device
1. Confirm that your cell phone supports NFC
pairing.
2. Make sure that NFC is enabled on your cell
phone.
3. Turn the S450-XT on.
4. Place the NFC zone of your cell phone against
the NFC zone of the S450-XT and hold
together while your cell phone registers the
headset.
5. Follow the prompts on your cell phone until it
confirms pairing is successful.
Note: NFC and one-touch pairing are dependent
on your cell phone. The size and sensitivity of your
phone’s NFC zone and how to connect the headset
may vary between devices.
NFC Zone