User Guide

VXi B250-XTS User Guide
PAGE 9
Pairing with a Phone
Keep headset and phone no less than 3 inches and no more than 3 feet apart while pairing.
Keep other Bluetooth devices at least 50 feet away, or turn them off.
NOTE: The headset can be paired with up to 8 different devices but can only be connected to one at a time.
It can only switch back and forth between 2 devices in Multipoint Mode.
• Turn headset off.
• Hold down the headset’s MFB until the lights alternate red and blue or you hear the audio prompts
“Power On” and then “Discovering.” IMPORTANT: Wait for both audio prompts or the alternating blue
and red lights. This may take up to 10 seconds. Then release the MFB.
• Put your cellular phone into Bluetooth Search/Scan Mode per the manufacturer’s instructions.
• Wait while the devices discover each other: This could take up to 2 minutes. Once the phone discovers
the headset, select “Pair” on the phone and enter a pass code of “0000” if instructed. Once pairing
is complete the alternating lights will stop flashing and the phone may prompt you to connect to the
headset. Select “Yes” on the phone to connect to the headset. When connected, you will hear the
voice prompt, “Your headset is connected,” and the blue light will flash indicating that the headset is in
Standby Mode and is ready to make or receive calls.
Pairing with a Computer
Keep headset and computer no less than 3 inches and no more than 3 feet apart while pairing. Keep all
other Bluetooth devices at least 50 feet away, or turn them off.
• Turn headset off.
• Open the computer’s Bluetooth connection manager.
• Put headset into pairing mode.
• Instruct Bluetooth connection manager application to discover Bluetooth device. Enter the passcode
“0000” when prompted.
• Wait while the devices discover each other. This could take up to 2 minutes. Once paired the headset’s
blue light will flash.
• After pairing is complete, a headset icon will appear in the computer’s Bluetooth connection manager
window. To connect the headset, use the mouse to right click on the headset icon and select
“connect.” Once connected you should hear the voice prompt, “Your headset is connected.”
• To disconnect, use the mouse to right click on the headset icon and select “disconnect” or power off the
headset. If you select disconnect you should hear the voice prompt, “Your headset is disconnected.”
PAIRING