BG952-V Specifications Sheet
Table Of Contents
Page 1
BG952-V
PRODUCT SPECIFICATIONS
CONFIGURATIONS
•
Upflow / Horizontal
•
Downflow
VENTING
•
2-speed induced draft motor with stainless steel shaft, steel ball
bearings, and fan cooled for long life
•
Vent materials for Canadian applications must comply with ULC S636
•
Certified for direct vent (2-pipe) or non-direct (1-pipe) applications
•
Direct vent refers to a combustion air supply intake pipe installed in
conjunction with flue gas vent pipe.
INSTALLATION FEATURES
•
Left or right gas and electric entry
•
Zero step horizontal conversion
•
Removable floor base (upflow/horizontal units) for bottom return air
•
All models comply with California's South Coast Air Quality
Management district Low NOx requirements
TWO STAGE VARIABLE SPEED
GAS FURNACE
FORM NO. BG952V-100 (10/2018)
HEAT EXCHANGER DESIGN
•
Aluminized steel primary heat exchanger with crimped non-
welded construction
•
AL29-4C Stainless steel secondary heat exchanger
•
Non-welded crimped S-curve primary heat exchanger design
for maximum durability
BURNERS
•
Aluminized steel in shot burners for smooth ignition
•
Isolated burner enclosure for quiet operation
CABINET CONSTRUCTION
•
Compact 33" height
•
Standardized widths for easy coil fit
•
Unitized construction for cabinet integrity
•
Heat exchanger compartment is insulated to increase
efficiency and reduce sound levels
•
Baked on pre painted steel cabinet finish
AIR DELIVERY SYSTEM
•
Efficient ECM variable speed blower motor
•
Motor features "soft start" and "soft stop" for quiet operation
•
Active and passive dehumidification feature
•
Easily removable slide-out blower design
•
Dynamically balanced blower wheel with resilient
motor mounts for smooth and quiet operation
CONTROLS
•
Two stage gas valve
•
Integrated ignition and fan control
•
System Sentry™ control retains last five (5) fault codes with
push button memory recall, regardless of power interruption
•
Hot surface ignition system uses silicon nitride ignitor
•
Control features 120 volt electronic air cleaner and humidifier
terminals
•
Control circuit is fuse protected
•
Color coded control wiring
•
Compatible with single or two stage thermostats for heating.
•
Two stage thermostat is recommended when installed with
two stage cooling unit.
WARRANTY
10 year limited parts warranty / lifetime heat exchanger warranty
available. See limited warranty document for details.
California Only
If installed in South Coast Air Quality Management District (SCAQMD) only: This
furnace does not meet the SCAQMD Rule
1111
NOx emission limit (14 ng/J), and
thus is subject to a mitigation fee of up to $450. This furnace is not eligible for the
Clean Air Furnace Rebate Program: www.CleanAirFurnaceRebate.com.
If installed in San Joaquin Valley Air Pollution Control District (SJVAPCD) only:
This furnace does not meet the SJVAPCD Rule 4905 NOx emission limit (14 ng/J),
and thus is subject to a mitigation fee of up to $450.