Ceiling Cassette Air Handler Installation Manual

8
Decorative Panel Installation
Fig 8.1
Fig 8.3
Fig 8.6
Fig 8.7
Fig 8.8
Fig 8.4
Fig 8.2
Detach the intake grille
Slide the 2 grille hooks toward the
middle of the decoration panel.
Mount the intake grille
After installing the decoration panel, ensure that
there is no space between the unit body and
decoration panel. Otherwise air may leak through
the gap and cause dewdrop. See gure below.
Install the decoration panel
• Align the indicate " " on the decoration panel
to the indicate " " on the unit .
• Attach the decoration panel to the unit with
the supplied screws as shown in gure below.
1 - Intake grille
2 - Grille hook
Ensure that the grille is
properly seated in the
groove of the panel.
Fasten the control box
lid with 2 screws.
Connect the 2 wires
of the decoration
panel to the main
board of the unit.
Leave third wire plug
detached.
Close the intake
grille, and close the
2 grille hooks.
Open the intake
grille and remove
1 - Decoration panel
2 - Screws (M5) (supplied with the panel)
1
2
1
2
10-cor
e wire
5-core
wire
 Page 17 
Revised 5/14/2020
Decorative Panel
Installation