U-Match Single Zone Installation Manual
Table Of Contents
- Slide Number 1
- Slide Number 2
- Slide Number 3
- Slide Number 4
- Slide Number 5
- Slide Number 6
- Slide Number 7
- Slide Number 8
- Slide Number 9
- Slide Number 10
- Slide Number 11
- Slide Number 12
- Slide Number 13
- Slide Number 14
- Slide Number 15
- Slide Number 16
- Slide Number 17
- Slide Number 18
- Slide Number 19
- Slide Number 20
- Slide Number 21
- Slide Number 22
- Slide Number 23
- Slide Number 24
- Slide Number 25
- Slide Number 26
- Slide Number 27
- Slide Number 28
- Slide Number 29
- Slide Number 30
- Slide Number 31
- Slide Number 32
- Slide Number 33
- Slide Number 34
- Slide Number 35
- Slide Number 36
- Slide Number 37
- Slide Number 38
- Slide Number 39
- Slide Number 40
- Slide Number 41
- Slide Number 42
- Slide Number 43
- Slide Number 44
- Slide Number 45
- Slide Number 46
- Slide Number 47
- Slide Number 48
- Slide Number 49
- Slide Number 50
- Slide Number 51
- Slide Number 52
- Slide Number 53
- Slide Number 54
- Slide Number 55
- Slide Number 56
- Slide Number 57
- Slide Number 58
- Slide Number 59
- Slide Number 60
- Slide Number 61
- Slide Number 62
- Slide Number 63
- Slide Number 64
- Slide Number 65
- Slide Number 66
- Slide Number 67
- Slide Number 68
- Slide Number 69
- Slide Number 70
- Slide Number 71
- Slide Number 72
- Slide Number 73
- Slide Number 74
- Untitled
Pipe Connection Interconnection Wiring Wired Controller Connection Dry Contacts
Cassette Units Duct Units Ceiling & Floor Console Special Tips
Remote alarm ports (CN33)
There are reserved ports for connecting a remote alarm installed in central control room or somewhere
like it, which will be active when the A/C unit is faulty or in a protection state.
These 2 ports are dry contacts and there
is no power output but a ON/OFF signal.
The alarm components and the power
supply are prepared by the users or
installers.