Hyper Heat Multizone Installation Manual

 Page 20 

Wiring

Wiring Figure

One-two models:

NOTE:Use the magnetic ring ( not supplied, optional part) to hitch the connective cable of

indoorand outdoor units after installation.One magnetic ring is used for one cable.

POWER

SUPPLY

L(A)

S(A)

N(A)

L(B)

N(B)

S(B)

Y/G

L( 1)

NOTE: Refer to the following figures if end-users wish to perform their own wiring.

Run the main power cord through the lower line-outlet of the cord clamp.

---- This symbol indicates field wiring.

CAUTION

Connect the connective cables to the terminals, as identified, with their matching numbers

on the terminal block of the indoor and outdoor units. For example, in the US models shown

in the following diagram, Terminal L1(A) of the outdoor unit must connect with terminal L1

on the indoor unit.

Model A

Model E Model F Model G

Model B Model C Model D

OPTIONAL