Hyper Heat Multizone Installation Manual

ManualsBrandsBlueridge ManualsDuctless Mini Splits48,000 BTU 21.5 SEER Hyper Heat Ductless Mini-Split Five Zone Heat Pump

 Page 23 

Wiring

CAUTION

After confirmation of the above conditions, follow these guidelines when performing wiring:

• Always have an individual power circuit specifically for the air conditioner. Always follow

the circuit diagram posted on the inside of the control cover.

•

• Check the specifications for the power source.

• Confirm that electrical capacity is sufficient.

• Confirm that the cable thickness is as specified in the power source specifications.

• Always install an earth leakage circuit breaker in wet or moist areas.

Screws fastening the wiring in the casing of electrical fittings may come loose during

transporation. Because loose screws may cause wire burn-ou, check that the screws are

tightly fastened.

• The following can be caused by a drop in voltage: vibration of a magnetic switch,

damaging the contact point, broken fuses, and disturbance of normal functioning.

• Confirm that starting voltage is maintained at more than 90 percent of the rated voltage

marked on the name plate.

• Before accessing terminals, all supply circuits must be disconnected.

• Disconnection from a power supply must be incorporated into the fixed wiring. It must

have an air gap contact separation of at least 3mm in each active (phase) conductors.

NOTE:

To satisfy the EMC compulsory regulations, which is required by the international standard

CISPR 14-1:2005/A2:2011 in specific countries or districts ,please make sure you apply the

correct magnetic rings on your equipment according to the wiring diagram that adhere to

the your equipment .

Please contact your distributor or installer to get further information and purchase

magnetic rings (The supplier of magnetic ring is TDK（model ZCAT3035-1330） or similar) .

Model E

Model C Model D

OPTIONAL

LPPUS REWOP Y

1(A)

2(A)

3(A)

1(B)

2(B)

3(B)

1(C)

2(C)

3(C)

1(D)

2(D)

3(D)

1(E)

2(E)

3(E)

TO A

TO B

TO D

TO E

TO C

OPTIONAL

Model F

L(C)

N(C)

S(C)

L(D)

N(D)

S(D)

L(E)

N(E)

S(E)

TO D

TO E

TO C

L(A)

N(A)

S(A)

L(B)

N(B)

S(B)

TO A

TO B

OPTIONAL

LPPUS REWOP

OPTIONAL