Single Zone Energy Star IDU Owners Manual

7
button
button
●
●
●
This is a general use remote controller. It could be
used for the air conditioner with multifunction. For the
functions which the model doesn't have, if press the
corresponding button on the remote controller, the
unit will keep the original running status.
After putting through the power, the air conditioner
will give out a sound. Power indicator " " is ON.
After that, you can operate the air conditioner by
using remote controller.
Under on status, pressing the button on the remote
controller, the signal icon " " on the display of
remote controller will blink once and the air condition-
er will give out a
"di" sound, which means the signal
has been sent to the air conditioner.
Under off status, set temperature and clock icon will
be displayed on the display of remote controller (If
timer on, timer off and light functions are set, the
corresponding icons will be displayed on the display
of remote controller at the same time); Under on
status, the display will show the corresponding set
function icons.
Press this button to turn on the unit. Press this button
again to turn off the unit.
Press this button, Auto, Low, Medium-low, Medium,
Medium-high, High speed can be circularly select-
ed. After powered on, auto fan speed is default.
Under dry mode, low fan speed only can be set up.
●
NOTE
Introduction for buttons on
remote controller
ON/OFF
FAN
ATUO
Medium fanLow fan
High fan
Medium-low fan
Medium-high fan
button
button
Under cool or heat mode, press this button can turn on
or turn off the turbo function. After the turbo func-
tion turned on, the signal of turbo will display. The
signal will be automatically cancelled if changing the
mode or fan speed.
TURBO
Press " + " or " - " button once increase or decrease
set temperature 1°C (°F). Holding " + " or " - "
button, set temperature on remote controller will
change quickly. On releasing button after setting is
finished, temperature indicator on indoor unit will
change accordingly.
When setting TIMER ON, TIMER OFF or CLOCK,
press " + " or " - " button to adjust time. (Refer to
CLOCK, TIMER ON, TIMER OFF buttons)
button
MODE
Press this button, Auto, Cool, Dry, Fan, Heat
mode can be selected circularly. Auto mode is
default while power on. Under Heat mode, the
initial value is 28°C(82°F ) Under other modes,
the initial value is 25°C(77°F).
Heat mode: Only for models with heating function.
Under auto mode, temperature can’ t be displayed;
Under auto mode, set temperature can’ t be adjusted.
●
●
NOTE
HEAT
AUTO COOL DRY FAN
It's low fan speed under dry mode.
X-FAN function Hold fan speed button for 2s in cool
or dry mode, the icon " " is displayed and the in-
door fan will continue operation for a few minutes in
order to dry the indoor unit even though you have turn-
ed off the unit. After energization, X-FAN OFF is
defaulted. X-FAN is not available in auto, fan or heat
mode.
●
●
NOTE
This function indicates that moisture on evaporator of
indoor unit will be blowed after the unit is stopped to
avoid mould.
●
Having set X-FAN function on: After turning off the
unit by pressing " ON/OFF " button indoor fan will
continue running for a few minutes. at low speed.
In this per- iod, Hold fan speed button for 2s to stop
indoor fan directly.
Having set X-FAN function off: After turning off the
unit by pressing " ON/OFF " button, the complete
unit will be off directly.
●
●