Single Zone Energy Star IDU Owners Manual

8
Press this button, the clock can be set up, signal
blink and display. Within 5 seconds, the value can
be adjusted by pressing + or - button, if continu-
ously press this button for 2 seconds above, in
every 0.5 seconds, the value on ten place of minute
will be increased 1. During blinking, repress the
clock button or confirm button, signal will be
constantly displayed and it denotes the setting
succeeded. After powered on, 12:00 is defaulted
to display and signal will be displayed. If there
is signal be displayed that denotes the current
time value is clock value, otherwise is Timer value.
button
CLOCK
The function is only available for some models.
●
NOTE
" 、 、 " may not be available. When air condi-
tioner receives this signal, the air conditioner will
blow fan automatically.
●
NOTE
Press this button to set left & right swing angle cycling
as below:
button
OFF
button
Press this button to set swing angle, which circular-
ly changes as below:
OFF
When selecting " ", air conditioner is blowing
fan automatically. Horizontal louver will automatically
swing up & down at maximum angle.
When selecting " 、 、 、 、 ", air condi-
tioner is blowing fan at fixed position. Horizontal
louver will stop at the fixed position.
When selecting " 、 、 ", air conditioner is blow-
ing fan at fixed angle. Horizontal louver will send air
at the fixed angle.
Hold " " button above 2s to set your required
swing angle. When reaching your required angle,
release the button.
button
TIMER ON TIMER OFF
●
Timer On setting: Signal "ON" will blink and
display, signal will conceal, the numerical
section will become the timer on setting status.
During 5 seconds blink, by pressing + or - button
to adjust the time value of numerical section,
every press of that button, the value will be
increased or decreased 1 minute. Hold pressing
+ or - button, 2 seconds later, it quickly change,
the way of change is: During the initial 2.5 sec-
onds, ten numbers change in the one place of
minute, then the one place is constant, ten num-
bers change in the tens place of minute at 2.5
seconds speed and carry. During 5s blink, press
the timer on button, the timer setting succeeds.
The timer on has been set up, repress the timer
●
on button, the timer on will be canceled.Before
setting the timer, please adjust the clock to the
current actual time.
One press this key to enter into TIMER OFF
setup, in which case the TIMER OFF icon will
blink. The method of setting is the same as for
TIMER ON.
●
●
Press this button, you can see indoor set tem-
perature, indoor ambient temperature or outdoor
ambient temperature on indoor unit's display. The
setting on remote controller is selected circularly
as below:
button
TEMP
no display
When selecting " " with remote controller or no
display, temperature indicator on indoor unit dis-
plays set temperature. When selecting " " with
remote controller, temperature indicator on indoor
unit displays indoor ambient temperature; When
selecting " " with remote controller, temperature
indicator on indoor unit displays outdoor ambient tem-
perature. 3s later it will return to the setting tem-
perature or it depends on the other received signal
within 3s.
Attention: When displaying the outdoor ambient,
the displaying range is 0-60°C（32-140℉）. When it
goes beyond the range, it keeps the threshold data
(The smallest — 0°C（32℉） and the largest 60°C（
140℉）).
Warm tips: When operating buttons on the cover
please make sure the cover is closed completely.