BMKH24M-NDG3 Owners & Installation Manual

Blueridge Owners Manual

Document Version: 11/2016

Draining

Connect the multiconductor wire

• The drain hose can be connected to either side of the air handler. There

is a plug on one end and a drain hose on the other. To properly drain the

indoor air handler, connect the drain tube to the same side as the copper

lines. Insert the drain plug in the other side.

• Insulate the Drain Tubing.

• Open the front panel of the indoor air handler, remove the screw on the

wiring cover, and remove the cover.

• There is a cable-cross hole on the back of the indoor air handler. Run the

power connection (multiconductor) through this hole and pull it from the

front side as seen in Img 4a.

• Remove the wire clip and connect the wires to each terminal. Please note

that the associating wires MUST match the terminals of the outdoor unit.

Color coded multiconductor is highly recommended as seen in Img 4b.

• Put the wiring cover back in place and tighten the screw.

• Close the front panel of the indoor air handler.

Installation of the Indoor Air Handler