BMKH24M-NDG3 Owners & Installation Manual

Blueridge Owners Manual

Document Version: 11/2016

NOTE

• When the power is connected (stand by condition), you can

operate the air conditioner using the remote control.

• When the unit is on, each time you press a button on the

remote controller, the sending signal icon “ “ on the display

of remote control will blink once. If the air conditioner beeps,

that means the signal has been sent.

• When unit is off, set temperature will be displayed on remote

controller (If the light of indoor unit is turned on, the corre-

sponding icon will be displayed); When the unit is on, it will

display the icon of the on-going function.

On/Off Button

MODE Button

Press the ON/OFF Button to turn the unit ON/OFF

Pressing this button once can select your required mode circularly as below

(the corresponding icon “ “ will be lit up after the mode is selected):

• When selecting auto mode, the air handler will operate automatically,

according to ambient temperature. The set temps are 77

F for cooling

and 68

F for heating and they cannot be adjusted and won’t be displayed.

Press the FAN button to adjust the fan’s speed.

• When selecting cool mode, the air handler will provide cooling. Press +

or - button to adjust set temperature. Press the FAN button to adjust the

fan’s speed.

Buttons on Remote Control

AUTO COOL DRY FAN HEAT(Only for models with heating funtion)

15 SEER Unit Remote