BMKH24M-NDG3 Owners & Installation Manual
Blueridge Owners Manual
57
Document Version: 11/2016
Copyright 2016 Alpine Home Air Products
• All Blueridge indoor air handlers come with air filters installed
• Optional air filters are available
5
5
17
18
Installing Optional Air Filters
Start Up
To Install the Filter:
• Lift the front panel and remove the air filter
• Attach the optional filter into the air filter
• Reinstall the air filter and close the panel
Complete a full system check prior to starting the system
• Make sure the drain hose slopes downward along entire length.
• Ensure the refrigerant pipes and connections are properly insulated.
• Fasten the pipes to the outside wall, whenever possible.
• Seal and weatherproof the wall hole where the multiconductor and refrig-
erant lines pass through.
• Turn on the electrical source and power up the outdoor unit.
• Push the ON/OFF button on the Remote Control to begin testing.
NOTE
A protection feature prevents the system from being activated for
approximately 3 minutes after power is initiated.
Start Up