Installation & Owners Manual 2017

Blueridge Owners Manual

Document Version: 01/2017

Piping Orientation

• For right rear exit, the drain tube must be relocated from the left drain

port to the right drain port, and the drain port plug replaced in the left

side. Once both refrigerant and drain lines are on the right side, they can

be carefully straightened, bundled together with the control wire and go

directly out of the wall. Attachments are made outside.

Installation of the Indoor Air Handler

The refridgerant pipes and drain tube can exit the air handler in four different

locations. Right and left rear exits are the most common - used when going

directly out of the wall behind the air handler unit. Right and left side exits are

used when refrigerant line must be run along an inside wall before exiting the

house. Right side exit is beyond the scope of most non-professionals and is

not recommended.

• For left rear exit, the refrigerant line remains in the same position as

shipped - bent across the back. Refrigerant connection is made behind

the unit, inside the house. Do not move the drain hose position. Bundle

the lineset, drain hose and control wire together. Drain hose connection

will be made outside the house.

• You must remove the cover and use the knockouts to create an opening

in the right or left side. See Image 3

• For left side exit, connect to lineset behind the unit and exit the left side

knockout. Do not move the drain hose from the factory location.

Rear Exit:

Side Exit: