Installation & Owners Manual 2017

Blueridge Owners Manual

Document Version: 01/2017

Mount the Outdoor Unit

• Mount the outdoor unit to a concrete pad, plastic pad, or wall bracket of

your choice, using the foot holes and bolts.

Connect the Copper Lines

• Remove the screw on the right handle of the outdoor unit.

• Slide the cover down to take the panel off and expose the valves.

• Remove the protective screw caps from the valves.

• Connect the pipe joint of the outdoor unit with the flared end of the cop-

per line set. If the copper pipes are not flared already, please reference

the Copper Line Flaring section of this document (page 54).

• Tighten the union nut (compression fitting) by hand.

• Place the open-ended wrench on the pipe joint and place the torque

Img 7 | Footholes located at the botton of the outdoor unit

Installation of a Single Zone Outdoor Unit

Foot Holes